(Message sent via IEEE Standards webmail)
-----------------------------------------

Commenter = Glen Kramer
Affiliation = Broadcom
SenderEmail = gkramer@broadcom.com
SenderPhone = (707)529-0917
StandardRev = IEEE Std 1904.1-2013
SubclauseNumber = 14.4.5.6.5
Page = 658

Rationale = Units for the action acLaserTxPowerOff (0xD9/0x06-05) should be milliseconds, not seconds.
In DPoE 1.0, the units were ms, but inadvertently changed to seconds in DPoE2.0. There has been an 
ECR submitted against DPoE2.0 to change the units back to ms. SIEPON Package A should align to the 
new unit value as well.

Using units of milliseconds is a more reasonable approach. It will allow operators to implement 
automatic troubleshooting methods, where a laser in each ONU can be shut down for a few milliseconds 
without affecting services. For a manual operation, laser still can be shut down until explicitly enabled.

ProposedChange = Change unit of acLaserTxPowerOff (0xD9/0x06-05) action from 1 second to 1 
millisecond.

Impact = Changes the expected behavior of acLaserTxPowerOff action, but shall not result in network 
operation issues.


-----------------------------------------
(End of IEEE Standards webmail message)